| SpaceCAD LESSON 2. Drawing setup STEP 3. Set line type and text type. |
The Set
Line Type  command in the Settings section
of the menu enables you to control the thickness and type
of lines that are created by the drawing command. For
example, here's the same line that was drawn back in Step 2 using the hidden line type.
You can change the
appearance of lines that you have already drawn using the
Change Line Type Similarly, you can
control the size of text on your drawing using the Set
Text Type
This concludes Lesson 2 on Drawing Setup. Lesson 3 is a simple project using what you've learned about drawing setup and the Line and Text commands. If you have questions, comments or suggestions regarding this lesson, please use our feedback form. |
command.
command. Shown below are the four
sizes of type that are available in CadStdŽ. You can
change the size of existing text using the Change
Text Type 
Command. 