| SpaceCAD LESSON 11: Isometric Drawing: Shuttle Restraints STEP 4: Drawing the legs |
| Now
we will draw the legs to the platform. Set the Snap
from Grid to None. Then you will use the Line
command to draw two 270 degree lines that are 4.5"
in distance. The lines should be 0.5" apart from
each other. Start drawing the lines at the bottom edge of
the platform. Here is what it will look like:
Now use the Copy
Click on Next to go to Step 5. |
command to copy 1 of the lines.
You will copy the line 4 times to the other two bottom
corners. Make each of these lines 0.5" in distance
from each other. After doing this, use the Line
command and make the lines at both legs even with each
other. Here's what it should look like: