this lesson you will use these CAD commands:
|| Polar Array
In Lesson 4, you
drew a section of the Mercury capsule console. In this
lesson, you will focus on another section. Look at the
completed drawing below and visualize the steps involved.
There are a few new commands you will learn that will
make this project much simpler, including Polar Array,
Rotate and Scale.
Click here if you would like to see a
slide show of this project.
Click here if you would like to see the original NASA
drawing of the Mercury space capsule main instrument
panel that was the basis for this project.
Click here if you would like to learn about the
history of the Mercury program.
Click here to start