Clown
by Yurii & Katrin Shumakov
Bell-Hat
Bell-Hat
For Hat, use a square of paper, 10x10 cm in size.
1 Valley fold the opposite corners together in turn to mark the diagonal fold-lines, and open them up.
2 Turn the paper over.Valley fold the opposite sides and edges together and open them up.
3 Move together lateral corners, simultaneously approaching the top corner to bottom.
4 Valley fold the model in half and open it up.
5 Open out the left-hand flap of paper and squash it into a triangle.
6 Valley fold the front flap's lower sloping edges over, so they lie along the middle fold-line. Press the flat and unfold them.
7 Open out the flap's horizontal edge. And inside reverse fold the right- and left hand points as shown.
8 Mountain fold the bottom points inside the model.
9 This should be the result.
10 Turn the model over. Repeat steps 5-9.
11 By pressing on the lateral sides give to a bell-hat the round form.
12 Slightly by turning out edges of petals, give them a natural view.
13 Hat for Clown is ready!
