Clown

by Yurii & Katrin Shumakov

Head

Trousers

Jacket

Collar

Head

Bell-Hat

Assembly

For the head of Clown, use a square of paper, 12,5x12,5 cm in size.

1 Valley fold a sheet on a diagonal.

2 Valley fold a triangle half-and-half.

3 Open "pocket" and straighten it in a square.

4 Turn the model on other party and again open "pocket", by straightening it in a square.

5 Repeat the step 4.

6 It is one of ways of folding of the base form "square".

7 Open and smooth "pocket". For simplification of the given operation make a preliminary crease, by combining edge of the top layer with the central line.

8 Repeat the previous operation for three other "pockets".

9 Turn the model over and make creases.

10 Valley fold the lateral edges, combining them with the central line. Repeat behihd.

11 Valley fold right-hand layer over to the left. Repeat behihd.
12 Repeat step 10.
13 Repeat step 11.
14 Valley fold the corner upwards as far as it probably.
15 The result. Repeat step 14 for other corners.
16 Hold the paper loosely and blow gently into small hole.
17 Omit corners in front and behind, compressing them on creases. Undertake lateral corners and turn them in the direction by the arrows, forming an ears.
18 The result.

The head of Clown is ready!