Clown
by Yurii & Katrin Shumakov
Jacket
Jacket
For the jacket of Clown, use a square of paper, 20x20 cm in size.
1 Valley fold the opposite corners together in turn to mark the diagonal fold-lines, and open them up.
2 Turn the paper over. Valley fold the opposite sides and edges together and open them up.
3 Valley fold the top and bottom corners to the centre.
4 Step fold the paper as shown.
5 Valley fold and unfold the sides along the adjacent edges.
6 Make the creases.
7 Step fold the paper as shown.
8,9 Turn the model around. Fold down the lateral corners, simultaneously bringing the top corner to bottom.
10 Valley fold and unfold all layers as shown.
11 Valley fold the opposite edges to meet the vertical line and unfold them. Repeat it behind.
12 Inside reverse fold the side points. Repeat it behind.
13 Valley fold the right-hand flap over to the left, as though turning the page of a book. Repeat it with the back side.
14 Open the model.
15 Make the creases, as shown in figure. Then combine the left and right sides, simultaneously pressing in the specified places and pulling together the top and bottom edges.
16
The following steps - formation of brushes of hands. These operations
are made equally both for one, and for other brush, therefore for convenience
in figures half of model is shown only.
17
Fold the lower sloping edge and insert it under the top layer.
18
Fold the upper sloping edge.
19
Mountain fold the received corner inside, making the lock.
20
Valley fold the tip of a brush and fold the large finger slightly.
21
Bring the side points together.
22
Fold and unfold half-and-half top triangle.
23
Sink the top corner, by opening model.
24 Jacket for Clown is ready!
