Clown

by Yurii & Katrin Shumakov

Trousers

Trousers

Jacket

Collar

Head

Bell-Hat

Assembly

Fort he trousers of Clown, use a square of paper, 20x20 cm in size.

1 Valley fold the opposite corners together in turn to mark the diagonal fold-lines, and open them up.

2 Turn the paper over.Valley fold the opposite sides and edges together and open them up.

3 Move together lateral corners, simultaneously approaching the top corner to bottom.

4 Valley fold the lower sloping edges over, so they lie along the vertical middle line. Valley fold the top point down as shown. Press them flat and unfold them.

5 Pinch and lift up the front flap of paper, so that its edges meet in the middle.

6 The result. Turn the model over.

7 Repeat steps 4-5.

8 This completes the bird base. Valley fold the right-hand flap over to the left, as though turning the page of a book. Repeat it with the back side.

9 Valley fold the bottom point to top.
10 Valley fold the top layer to itself on a line of internal sloping edges which is shown by an invisible line. Press the limited creases and unfold them.
11 Valley fold the front layer on crossing of fold-lines made in step 10. Unfold it.
12 Open the layers and pinch the sides together in the marked place, so that its edges meet.
13 Bend the corner to the right.
14 Valley fold the front layer to bottom.
15 The result. Repeat steps 9-14 behind.
16 This should be the result.
17 Make the clown's feet by inside reverse folding the bottom corners.
18 Press from two parties, giving them volume.

And the trousers for Clown are ready!