Bells

by Yurii Shumakov

Use 2 squares of paper, identical in size and strip of paper. You will also need a string and needle.

For learning this model is better to take a paper by the size approximately 20x20 cm.

1 Valley fold the opposite corners together in turn to mark the diagonal fold-lines, and open them up.

2 Turn the paper over.Valley fold the opposite sides and edges together and open them up.

3 Move together lateral corners, simultaneously approaching the top corner to bottom.

4 Valley fold the model in half and open it up.

5 Open out the left-hand flap of paper and squash it into a triangle.

6 Valley fold the front flap's lower sloping edges over, so they lie along the middle fold-line. Press the flat and unfold them.

7 Open out the flap's horizontal edge. And inside reverse fold the right- and left hand points as shown.

8 Valley fold the bottom corners to meet the marked places.

9 Mountain fold the bottom points inside the model.

10 This should be the result.

11 Turn the model over. Repeat steps 5-9.

12 By pressing on the lateral sides give to a bell the round form. A core of a bell open slightly.

13 Slightly by turning out edges of petals, give them a natural view.

14 The bell is ready.

Joining the elements together

Prepare two bells and strip of paper. You will also need a string and needle.

Bend a tape and combine with the top points of bells.
Then with the help of a needle and and string fix them together.
Make of a string a loop that the bells could be hung up.

Christmas Bells is ready!