Dino

by Katrin Shumakov

1 Valley fold the opposite corners together in turn to mark the diagonal fold-lines, and open them up.

2 Turn the paper over.Valley fold the opposite sides and edges together and open them up.

3 Move together lateral corners, simultaneously approaching the top corner to bottom.

4 Valley fold the lower sloping edges over, so they lie along the vertical middle line. Valley fold the top point down as shown. Press them flat and unfold them.

5 Pinch and lift up the front flap of paper, so that its edges meet in the middle.

6 The result. Turn the model over.

7 Repeat steps 4-5.

8 Valley fold the lower sloping edge over, so it lie along the vertical middle line. Repeat behind.

9 Inside reverse fold the bottom point into the position shown in the next step.

10 Valley fold the top layer to itself on a line of internal sloping edge which is shown by an invisible line.

11 Valley fold the top layer, align his bottom edge to top sloping edge.

12 Fold a corner along border of a back.

13 Fold a layer on the line which is taking place through the specified points.

14 Fold to the right edge of a layer, bending thus the bottom corner and forming a paw dino.

15 Repeat steps 10-14 for other side.

16 Generate a head dino. Valley fold the lower sloping edge over, so it lie along the vertical middle line. Repeat behind.

17 Step fold the corner on a head, forming a mouth. By opening layers of a tail, make iside reverse fold.

18 Press on the centre slightly, stretching the opposite edges.

Dino is ready!