[an error occurred while processing this directive]
Posted by Adam on June 07, 19103 at 18:36:13:
In Reply to: No Power after motherboard installation posted by Sam on July 31, 19102 at 17:13:18:
: I just installed a ECS motherboard and followed the pin placement for power switch and reset pin-outs, but when I plug it in, I get no power. Is there a common error that I am missing here?
When I built my first computer, I didn't know about the
spacers between the motherboard and case. This of course fried
the board, and at first made it seem as though it just wasn't
getting any power. I know you probably did, but make sure the
spacers are there.
Post a Followup