..The following is a step by step method you should follow when developing your film.

Step 25 - Take the reel out of the tank, and carefully unroll the film. Remove excess water from both sides of the film with a squeegee tong. (Make sure the tongs are clean so the film does'nt get scratched)
Step 26 - Hang the film to dry using a safety pin or some kind of clip. Make sure the area you are storing the negatives to dry is clean, cool, dust free, and dark. Make sure to put some kind of mild weight on the bottom so that your film does'nt curl.
Step 27 - When the film is thouroughly dry, cut it into strips of five or six frames.
Step 28 - OK, YOUR DONE! If you followed all the steps properly you should have a set of negatives ready to print. If you are not going to print immediately, store them in a negative sleeve.

 

.....