| Step
17 - About 10
seconds before the recommended time is to
expire, remove the print and allow it to drip
over the tray for the remainder of the time. |
|
| Step
18 - Slide the print
under the stop-bath for 10 to 15 seconds.
Then repeat the dripping process in the
previous step. |
|
| Step
19 - Slide the print
into the fixer for about 30 seconds. Note
that since it is only a test print this times
is greatly shortened for practical reasons. A
normal print would be left in there for about
3 or 4 minutes. |
|
| Step
20 - Wash it briefly
in water, they squeegee it to make it
semi-dry. Carry the print under a white light
and inspect the frames. Determine the correct
exposure and set the enlarger's time
accordingly. |
|
.....